2 March 2006

TMB preparation after receipt at 904 and before installation at SX5

I. visual inspection

A. damage from shipping? Anything loose? Bent? Smashed?

B. serial number on front = serial number on board?

C. check screws on J0-J4 SCSI connector -> should be 2 per board (total of 10)

D. check bolts/nuts on VME connector P1 -> should be 2

II. check switches/jumpers

A. Switches:

i. SW1 (vme adr lsb) = A

ii.SW2 (vme adr msb) = 1

iii.SW3 (jtag src) = 4 [SW3]

B. Jumpers (probably easier to just have pictures on website):

i. SH501 (clk src) = 1-2 [CCB] <- this is something to check

ii. SH502 (cfeb clk) = 2-3 [DCC]

iii. SH55 (gbl) = 1-2 [ENA]

iv. SH56 (geo) = 1-2 [ENA]

v. SH57 (adm) = 1-2 [REQ]

vi. SH97 (fpga) = 1-2 [ENA]

vii. SH69-1 (reg in) = 2-3 [REG]

viii. SH69-2 (reg out) = 2-3 [REG]

ix. SH95 (boot) = 1-2 [EN]

x. SH104 (vme) = 1-2 [EN]

xi. SH105 (ccb) = 1-2 [EN]

xii. SH106 (alct) = 1-2 [EN]

xiii. SH107 (self) = 2-3 [EN] <- this is something to check

xiv. SH1081 (alct) = 1-2 [EN]

xv. SH1082 (tmb) = 1-2 [EN]

xvi. SH1083 (rpc) = 1-2 [EN]

xvii. SH1084 (pup) = 1-2 [EN]

xviii. SH62 (vmeadr) = 1-2 [GEO]

xix. SH74 (jtag src) = 2-3 [SW3]

xx. SH921 (rat adc) = 1-2 [ACORE]